Softener Installation Directions

Softener Installation Directions:
HOOK THE GARDEN HOSE FROM YOUR WATER SUPPLY, TO THE INLET OF THE HEAD. THIS IS MARKED WITH AN IN ARROW.
THE BEST WAY IS TO PURCHASE A SHORT 4 FOOT HOSE FOR A WASHING MACHINE, AND USE THIS AS THE FEED WATER TO THE SOFTENER.
TAKE ANOTHER HOSE AND HOOK IT INTO THE OUT ARROW ON THE SOFTENER, AND YOU ARE READY FOR USE.

Regeneration Directions:

TO REGENERATE YOUR SOFTENER, FIRST REMOVE THE LID FROM THE TOP OF THE SOFTENER BY HAND. (DUMPING WITH LID OFF CAN RESULT IN LOSS OF RESIN). IF YOU NEED TO REMOVE WATER LEAVE THE LID ON AND DUMP OUT OF INLET OR OUTLET.

POOR THE LARGE MORTONS TABLE SALT INTO THE HOLE. (PICTURED BELOW)

REPLACE CAP AND LET SIT FOR AT LEAST 1 HOUR. TURN WATER ON AND LET FLUSH FOR 5-10 MINUTES. (THE EASY WAY TO CHECK TO SEE IF SALT IS FLUSHED OUT IS TO TAKE YOUR FINGER AND TASTE TEST THE OUT COMING WATER).
YOUR SOFTENER IS THEN READY TO GO AGAIN.
THIS IS DONE OVER AND OVER AGAIN, AND UNDER MOST WATER CONDITIONS THE MEDIA DOES NOT NEED TO BE REPLACED FOR AT LEAST 1-3 YEARS. (WE HAVE REPLACEMENT MEDIA AVAILABLE FOR YOU IF NEEDED)

NOTE: REGENERATE WATER SOFTENER AT LEAST ONCE A WEEK WHEN BEING USED TO PREVENT RESIN FROM FOULING.

Toll Free 1-877-477-5452

Check out our customer feedback.