The display will show three dashes with a decimal point.

1. Use arrows to set media volume 1.0=(32,000 grains) 1.25=(40,000 grains), 1.5= (48,000 grains) 2.0 =(64,000 grains) THEN HIT THE SET BUTTON.
 (there will be a blinking time)

3.Use the UP and DOWN arrows to set the time of day. When the correct time is displayed, push SET.

4.Setting the Day of the Week
The display will show a small cursor at the top of the display. Push SET to enter the programming mode. The cursor is moved with the arrow buttons to a position below the day of the week. Use the arrow buttons to move the cursor below the current day of
the week, hit SET to enter the day.

5.Push the SET button and toggle down to hardness and use the up and down arrows to enter in your water hardness in GPG and then press set.

NOTE: your capacity will be automatically calculated at this point so do not change that. The salt is already set for S which is standard so you can just leave that. Also leave the time of regeneration alone, as well as time between regeneration.

Your softener is now programmed and ready to operate.

Reset Logix Valve:

Down and set button for 3 to 5 seconds
Set button 3 to 5 seconds
Shows 3 dashes.
Use up arrow to set amount of media.
Use arrows to set media volume 1.0=(32,000 grains) 1.25=(40,000 grains), 1.5= (48,000 grains) 2.0 =(64,000 grains) THEN HIT THE SET BUTTON.